| Subject | Text |
| Datasheet for Ferguson T59N Nicam TV | Hi
I'm trying to find out the specification of the Ferguson T59N tv that I have, having lost the |
| Sony Lcd problems | I have a 32" Sony Bravia lcd tv. Half the screen the image is fine, the other half displays lin |
|
|
| Dell D1626HT Sony trinitron monitor.. needs fix please help | okay. im a micro-electronic engineer student in australia and i'm trying to fix my friends monitor. |
| If you don't know how to repair it then don't respond. Not to be a dick or nethin but I'm trying to |
| I have taken the connector "PPD5" off. It goes to the deflection. The power supply board's |
| Magnasonic MCT2800 | Got Vertical problems and none of the parts figure in the ECG Manual |
| Casio LCD module | Hi!
I have problems with a 5.5" Casio LCD module. The image is too big on the screen... I tried a |
| No OSD and menus on Mitsubishi VS-5071 | I just replaced the vertical amplifier in a 1993 Mitsubishi VS-5071. The picture looks good now. B |
| R781 Value | Hi.
I have this monitor. I m looking for this resistor on my chassis but i cant find. Where near |
| Hi!
This means then the stage of frame is fault,
You should check:
- is there voltage of power |
| Reverse the 2 wires to the horizontal deflection yoke. Do the same to the 2 wires of the vertical de |
| NEC MT800G picture fault | Hi
I have problem with my NEC MT800G LCD projector, the picture are
"distorted". No fault with the |
| dont forget to change low ohm resistor off flybackthat feeds the voltage usually 26volts to the vert |
| I would start by checking if there are bad solder joints on the mainboard.
Especialy in the defle |
| Re: JVC-AV29LX14 | [quote:0bec8e9903="jts1957"]What was "original" symptom?
Test diodes out of circuit?[/quo |
| Request for service manual Panasonic PVQ-2512 | I am a fairly old retired TV and Computer tech,since 1959, and I have vertical problem with my bedro |
| Possible bad joints on vertical output IC &/or pump-up electrolytic (100ufd/35volt usually). |
|
|
| Sony tv | Hi Buddy 128,
Resolder vertical output stage and check R518 , R519 (0R47)
Greetz,
Picasso |
| Is the single line dead center of the screen? From the left side all the way to the right side. IE l |
| Toshiba 2909XH TV | Hi. i need a Schematic Diagram for the Toshiba Model 2909XH. Especially the Vertical Deflection sect |
| AV-27820 | Hi there... I'm having some troubles with the vertical sweep on my 32" JVC AV-27820. I think it's th |
| jvc/tv | I HAD TWO FAULTS LIKE THAT STOP YOU HAVE DRY JOINTS ON
VERTICAL IC STOP GOOD LUCK :lol: |
| Sony KV-35v65 hv short | Many people distribute a parts kit for this model of television. It
includes a dual power supply t |
| [quote:94b4285df1="gary"]IF THE LINES ARE VERTICAL IE TOP TO BOTTOM THEN VERT STAGE IS OK AND FAULT |
| Check the flyback capacitor(s), those are usually 5-10 nF polypropylene capacitors connected from th |
| Technosat ir 7000 | Hi
I need circuit diagram for this reciver, having problem that 13v for lnb for vertical ,is ok b |
| It's vertical collapse |
| Sony KP-41S4 projection tv with convergence problem | The former owner replaced the picture tubes, introducing a convergence error for red and blue. After |
| I need service manual for Philips 21PT1321/75T (AUS Model) | I had a single vertical lines issue with this baby. Thought I first would be a defective vertical de |
| If you need current feedback to get a correct waveform through an inductive load, please take a look |